Skin Enhancer

The Skin Enhancer is a cleansing and rejuvenating facial device. It includes modes for deep cleanse, product penetration, facial contouring and calming. It integrates nanocurrent (EMS), heat, biomechanical vibration, red, blue, and orange LED plus cold for locking in product, closing the pores, and calming the skin.

*Ultrasonic Cleansing

*EMS (electrical muscle stimulation/nano current)

*Biomechanical Vibrations -- sends gentle vibrations (6000-7000 times per minute)

*Heat - warm massage promotes the absorption of products

-Red Light - 640nm-650nm red light helps to reduce fine lines and wrinkles

-Blue Light - 460nm-470nm helps calm skin

-Orange Light - 597nm-622nm helps repair and tone

-Cooling - helps tighten pores and lock in moisture

HOW TO USE

The Skin Enhancer consists of six modes. 

*Please read charging instructions before first use.

Hold the power button to turn the device on. 

Press the modality button to select Mode (see modes below). 

Press the Intensity Button to adjust the intensity level. 

*All modes include vibration to simulate muscles. You can change the level of vibration with the intensity button. EMS will also show up in all modes. You can shut off EMS or change the power level of EMS to any mode by quickly pressing the on/off button. There are five levels for EMS, the sixth press will turn EMS off. A seventh press will bring it back on to level one. 

Mode 1:

Ultrasonic Cleansing:  You can use ultrasonic cleansing mode with or without a cotton pad. If you don’t wear base makeup, no need to apply the cotton pad. 

Put a damp cotton pad on head of unit (remove the plastic ring, place a cotton pad on the head and place the plastic ring back on).

Apply Exfoliating Cleanser to face. Using circular movements around the face for 2 to 3 minutes, this mode can effectively clean the dirt from the pores making the skin translucent. 

OR Apply cleanser to face and use unit without cotton pad over the cleanser. Using circular movements around the face for 2 to 3 minutes. 

Frequency of use: 2-3 times a week. Reduce to once a week for sensitive skin.

Mode 2:

Seep: This mode includes EMS, Biomechanical Vibration, and Red LED for rejuvenation. 

Apply tone to a cotton round, and place on the head of unit. Place plastic ring on top of gauze. 

Gently glide across face for 1 to 2 minutes. This allows for a deeper cleanser, making sure that all makeup has been removed. (If you don’t wear makeup, you don’t need to use this mode). 

Mode 3:

Lift: This mode includes EMS, vibration, and heat. Best mode for toning and tightening. 

Mode 4: 

Restore: This mode includes EMS, vibration, and LED. This is your nourishing mode for driving the product deeper into the skin. Great for dehydrated skin or if there is an ingredient you want to drive deeper into the skin (i.e.: for pigmentation). You can use this with red, blue, or orange LED. Just press the mode button to change the LED color.

Mode 5: 

Eye: Gentle pulses stimulate sensitive eye area. Use a light pressing technique around the eye. Hold and press for two seconds, lift, and move to the next area. Repeat. Apply eye product first.

Mode 6: 

Cold: This mode includes blue LED light for calming. Use around puffy eyes, over pimples to calm, or over full face to lock in products. Try this mode if your skin needs calming from irritation. You can still use the EMS and vibration to tone while calming your skin

Included:

1 skin Enhancer device

1 charging cable

1 plastic ring holder

Training:

https://www.shelleyhancock.com/training/